NOTE: Enabling this setting can have an adverse effect on your performance. This is useful in various scenarios such as: This article will guide you on how to enable this on BlueStacks. The Click command uses the sending method set by SendMode.You can choose to get visual feedback on various clicks/taps you perform with your mouse on BlueStacks 5. The Click command is generally preferred over MouseClick because it automatically compensates if the user has swapped the left and right mouse buttons via the system's control panel. In other words, the cursor will be moved from its current position by X pixels to the right (left if negative) and Y pixels down (up if negative). Otherwise, specify the word Rel or Relative to treat the coordinates as offsets from the current mouse position. Relative: If omitted, the X and Y coordinates will be used for absolute positioning. For example, Click, Down presses down the left mouse button and holds it. Later, use the word Up (or the letter U) to release the mouse button. Otherwise, specify the word Down (or the letter D) to press the mouse button down without releasing it. Specify zero (0) to move the mouse without clicking for example, Click, 100 200 0.ĭownOrUp: If omitted, each click consists of a down-event followed by an up-event. If Coords is specified, ClickCount must appear after it. For example, Click, 2 performs a double-click at the mouse cursor's current position. Otherwise, specify the number of times to click the mouse button or turn the mouse wheel. For them, use the Click command multiple times by means such as Loop.ĬlickCount: If omitted, it defaults to 1. However, some applications do not obey a ClickCount value higher than 1 for the mouse wheel. ClickCount is the number of notches to turn the wheel. : WheelLeft (or WL) or WheelRight (or WR) may also be specified (but they have no effect on older operating systems older than Windows Vista). WhichButton can also be WheelUp or WU to turn the wheel upward (away from you), or WheelDown or WD to turn the wheel downward (toward you). Unlike MouseClick, the left and right buttons behave consistently across all systems, even if the user has swapped the buttons via the system's control panel. ![]() ![]() For example, Click, Right clicks the right mouse button at the mouse cursor's current position. Otherwise, specify Left, Right, Middle (or just the first letter of each of these) or X1 (fourth button) or X2 (fifth button). WhichButton: If omitted, it defaults to Left (the left mouse button). Coordinates are relative to the active window unless CoordMode was used to change that. For example, Click, 100 200 clicks the left mouse button at a specific position. Otherwise, specify the X and Y coordinates to which the mouse cursor is moved prior to clicking. ![]() The components can appear in any order except ClickCount, which must occur somewhere to the right of Coords, if present.Ĭoords: If omitted, the cursor's current position is used. Separate each component from the next with at least one space, tab, and/or comma. Otherwise, specify one or more of the following components: Coords, WhichButton, ClickCount, DownOrUp, and/or Relative. If blank or omitted, a single left click is performed at the mouse cursor's current position. It can also hold down a mouse button, turn the mouse wheel, or move the mouse. Click - Syntax & Usage | AutoHotkey Click Ĭlicks a mouse button at the specified coordinates.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |